Product manual

SKU 92020 For technical questions, please call 1-888-866-5797. Page 5
AC Voltage
Measurements
Measure AC conductors
carrying up to 750 VAC,
45-450 Hz.
1. Turn the Range
Selector Switch to
750 ACV setting.
Always start with
the highest range
if the voltage is
unknown.
2. Plug the red lead
into the VΩmA
(Center)Jack.Plug
the black lead into
theCOM(Bottom)Jack.Switch
the Multimeter ON.
3. Carefully touch the exposed
conductors with the tips of the
probes to measure the voltage (not amperes).
4. Read measurement.
If the voltage is less than 200 volts, set the Range Selector Switch to the
lower range.
5. When testing is complete, remove Test Leads and store with multimeter.
DC Voltage Measurements
Measure DC conductors carrying up to 1000 VDC.
1. Turn the Range Selector Switch to 1000 DCV setting.
2. Follow the directions above under “AC Voltage Measurements”, only use
the DC settings instead.
DC Current Measurements
Measure DC conductors carrying up to 10 amperes.
1. Turn the Range Selector Switch to the 10A position.
Always start with the highest range if the amperage is unknown.
2. Plugtheredleadintothe10A(Top)Jack.PlugtheblackleadintotheCOM
(Bottom)Jack.SwitchtheMultimeterON.
3. Carefully touch the exposed conductors with the tips of the probes to
measure the amperage.
Note: Amperage is always tested in series with the circuit under test.
4. Read measurement.
COM Jack
Volt/Ohm/
mA Jack
DC AMP
Selection
Area
Transistor
Selection
Area
ON/OFF
Switch
Control Layout
10A
Selection
Area/Jack
AC Volt Selection Area
Diode
Selection Area
Battery
Test
Selection
Area
Backlight
Button
Ohm
Selection
Area
Transistor
/hFE Jack
DC Volt
Selection
Area
REV 04k