Product manual

SKU 42397 / 95683 For technical questions, please call 1-800-444-3353 Page 5
OPERATION
Control Layout
DC Volt
Settings
AC Volt
Settings
AC Amp
Settings
Transformer
Jaws
COM
Jack
Volt/ Ohm
Jack
Trigger
Peak Hold
Button
EXT
Jack
Ohm
Settings
Insulation
Test
Settings
Diode Test
Setting
LCD
CAUTION
1. Avoid damaging meter. Use only as
specied in this manual.
2. Prior to testing capacitors,
resistance, diodes, or continuity;
disconnect all power to the circuit
and discharge all high-voltage
capacitors.
3. Performance of this meter may vary
depending on battery condition.
4. Use the proper settings, terminals,
techniques, and range for the tests
performed. Always start with the
range stated in the instructions.
5. Be careful not to apply voltage to the
Test Leads when they are connected
to the COM (common) and Volt/Ohm
Jacks and the Multimeter is in the
Ohms testing setting. Damage can
occur to the multimeter.
6. Do not switch between testing
modes with the multimeter
connected to a circuit.
UNPACKING
When unpacking, make sure the
following parts are included: Digital Clamp
Multimeter, black and red Test Leads, hand
strap, 9V battery, and carrying case. If any
parts are missing or broken, please call
Harbor Freight Tools at the number on the
cover of this manual.