Product manual
SKU 42397 / 95683 For technical questions, please call 1-800-444-3353 Page 3
Save This Manual
You will need the manual for the
safety warnings and precautions, and
operating and maintenance procedures.
Keep your invoice with this manual. Write
the invoice number on the inside of the front
cover. Keep the manual and invoice in a
safe and dry place for future reference.
IMPORTANT SAFETY
INFORMATION
In this manual, on the labeling,
and all other information
provided with this product:
This is the safety alert
symbol. It is used to alert
you to potential personal
injury hazards. Obey all
safety messages that follow
this symbol to avoid possible
injury or death.
DANGER indicates a
hazardous situation
which, if not avoided, will result
in death or serious injury.
WARNING indicates
a hazardous
situation which, if not avoided,
could result in death or serious
injury.
CAUTION, used with
the safety alert
symbol, indicates a hazardous
situation which, if not avoided,
could result in minor or
moderate injury.
NOTICE is used to
address practices
not related to personal injury.
CAUTION, without
the safety alert
symbol, is used to address
practices not related to
personal injury.
WARNING: If any warnings or safety
precautions in the owner’s manual are
not followed completely, the protection
provided by this product will be reduced.
Read all instructions before
using this tester!
WARNING
1. ELECTRICAL SHOCK CAN CAUSE
DEATH OR INJURY! NEVER TOUCH
EXPOSED CONDUCTORS OF
ELECTRICITY.
2. Inspect the Multimeter before use. In
addition to a general inspection, look
specically for:
a. Pay special attention to the insulation
protecting the connectors.
b. Check the leads for exposed metal,
damaged insulation, and continuity.
Replace damaged test leads
immediately, before use.
2. Remove the test leads before
performing maintenance,
opening the case, or the battery
compartment.
3. Do not use the multimeter if:
a. The test leads are damaged in any
way.
b. The battery is low.
c. Near any explosive gasses or fumes.
d. Any abnormal operation is detected.
(If in doubt about the condition of the
meter, have it serviced.)
e. The battery cover is open.
4. This meter should be powered only
by a single, correctly installed 9V
battery.