Product manual

Page 11For technical questions, please call 1-800-444-3353.Item 69064
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Release the Trigger, turn off the laser and
unplug the tool from its electrical outlet before
adjusting tool or installing accessories.
TO PREVENT SERIOUS INJURY
FROM FLYING FRAGMENTS:
Do not use blades made from high-speed steel,
abrasive blades, or metal- or masonry-cutting blades.
The guards of this saw are not designed to
protect against the failure of such blades.
To Remove/Install A Saw Blade (sold separately):
1. Lower the Base Plate to its lowest setting
(See Depth Adjustment, following).
2. Depress the Spindle Lock Lever to hold the
Saw Blade in place and unscrew (clockwise)
and remove the Blade Bolt and Outer Flange.
3. Pull the Lower Guard all the way up into the
Upper Guard. Remove the old Saw Blade
and install a new Saw Blade onto the Spindle.
4. Slide the Outer Flange onto the
Spindle with the cupped side towards
the blade, and wrench tighten the
Blade Bolt in place on the Spindle.
WARNING! Blade must be rated
to at least 5,500 RPM.
Note: Make sure to install the new Saw Blade
with its teeth and the arrow on the Saw Blade
pointing in the same direction as the arrow on the
Lower Guard.
Depth Adjustment
1. Loosen the Depth Lever.
2. Hold the Base down with one hand and raise or lower the
body of the Saw with the other hand until the Blade is at the
desired Depth of cut, using the Depth Gauge as a guide.
3. Tighten in place with the Depth Lever.
WARNING! To reduce the risk of Serious Injury:
Depth of cut must be adjusted to just clear the workpiece.
Angle Adjustment
1. Loosen the Angle Lock Knob.
2. Adjust the Base to the desired angle between 0°
and 45°, using the Angle Gauge as a guide.
3. Tighten in place with the Angle Lock Knob.
Spindle
Lock
Lever
Figure 2
Base
Outer Flange
Blade Bolt
Saw Blade
Lower
Guard
Lever
Lower Guard
Depth Lever
Depth Gauge
Figure 3
Base
Figure 4
Angle Lock
Knob
Base
Angle
Gauge
SAFETYOPERATIONMAINTENANCE SETUP