Product manual

Page 4 For technical questions, please call 1-800-444-3353. Item 69643
Specifications
Lamp 60 Super Bright White LEDs
Battery Pack 6V, 900mAh, NiCd Battery Pack
Solar Panel 6-1/4" x 5" Amorphous Solar Panel
Detects Motion Up to 50'
Range of Motion Up to 120°
Delay Time 5 to 120 Seconds (adjustable)
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 10.
Installation
1. Decide where you want to place the Lamp and the
Solar Panel. The Solar Panel is equipped with
a 16 ft. connecting wire, so the Lamp and Solar
Panel can be installed up to 16 ft. apart. The Solar
Panel must be set in a location that receives
full, direct sunlight, a minimum of eight hours
a day. Ideally, the solar panel should be angled
slightly toward the south (northern hemisphere).
2. Mount the Solar Panel:
a. Place the Solar Panel in the desired location,
adjusting the unit to best fit the surface.
b. Mark the hole locations of the Base,
then set the Solar Panel aside.
c. Check that the marked areas are clear of
obstacles such as cables and electrical
lines. Drill holes for the enclosed
Screws and plastic Anchors.
d. Insert the plastic Anchors then secure the
Solar Panel in place with the screws.
3. Mount the Lamp:
a. Locate the unit six to eight feet above ground
on a solid surface capable of supporting the
Lamp and secure enough so that it will not
move when exposed to vibrations or wind.
The unit must be high enough to allow for
motion detection and light distribution.
b. Mark the hole locations of the Mounting
Bracket, then set the Lamp aside.
c. Check that the marked areas are clear of
obstacles such as cables and electrical
lines. Drill holes for the enclosed Screws.
d. Secure the Lamp in place with the screws.
4. Carefully route the Power Cord of the Solar Panel
to the Lamp and plug it into the Battery Housing
Outlet on the back of the Battery Housing.
5. Loosen the Detector Angle Lock, swivel
the Motion Detector Head so that it faces
the area where movement will occur, and
tighten the Detector Angle Lock.
SAFETY OPERATION MAINTENANCESETUP