Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 01666
1. Attach Eye Bolts (15) to Ram Plate (11)
by threading Nuts (27) on 1/2” only.
Ram Plate
(11)
Nut
(27)
Eye Bolt
(15)
Figure L
16. Guide Press Pin through Press Pin Guides and
let Ram Plate rest on Upper Cross Beam.
17. Level and square all components, then tighten
all connections securely, except for Eye Bolts.
Press
Pin
Figure M
18. Pull up on Ram Plate and attach Eye Bolts to Springs.
19. Push Ram Piston all the way down,
then place Ram on Ram Plate.
Note: If more space is needed to
install Ram, loosen Eye Bolts.
20. When Ram is in place, tighten Eye Bolts evenly,
making sure the Ram Plate remains level.
21. Pump Ram Handle until Piston is seated firmly in
Piston Ring, then tighten Eye Bolts as needed.
22. Place Arbor Plates on Press Apron.
23. Follow instructions in
Bleeding the Ram on page 8.
Piston
Piston
Ring
Arbor
Plates
Figure N
24. Locate Shop Press on a solid, level surface,
capable of supporting the weight of the
Shop Press and the workpiece.