Product manual
Page 6 For technical questions, please call 1-888-866-5797. Item 01666
8. Slide Lower Cross Beam assembly between
Post assemblies and attach with two sets of
Bolts (17), Spring Washers (21) and Nuts (24).
Bolt
(17)
Spring
Washer
(21)
Nut
(24)
Figure G
9. Attach two Header Supports (3) together
with Bolt (19), Spring Washer (23) and
Nut (28), leaving a gap for the Header.
10. Repeat with other two Header Supports.
Header
Support (3)
Bolt
(19)
Spring
Washer
(23)
Nut
(28)
Figure H
11. Slide Header (1) between Header Support
assemblies and attach with two sets of Bolts (20),
Spring Washers (22) and Nuts (25).
Note: Tighten connections enough to avoid wobbling.
Nut
(25)
Spring
Washer
(22)
Bolt
(20)
Header
(1)
Figure I
Note: Use a helper for the next step.
12. Slide Upper Cross Beam assembly between Post
assemblies and, at the same time, place Header
Support assemblies outside Post assemblies.
13. Attach with two sets of Bolts (18),
Spring Washers (22) and Nuts (25).
Note: Tighten connections enough to avoid wobbling.
Bolt
(18)
Header
Support
Assembly
Upper
Cross Beam
Assembly
Spring
Washer
(22)
Nut
(25)
Figure J
14. Hang Springs (10) on Bolts that
connect Header Supports.
Spring
(10)
Figure K