Product manual
Page 5For technical questions, please call 1-888-866-5797.Item 01666
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found,
do not use tool until repaired.
Wear ANSI-approved safety goggles, heavy-duty work gloves,
and steel-toe work boots during set up and/or use.
Note: Finger tighten all connections until assembly
is done, unless instructed otherwise.
Assemble on a flat, level, hard surface.
Use a helper when necessary.
1. Attach Back (5) and Front (9) Posts
to Foot (8) with two sets of Bolts (16),
Spring Washers (21), and Nuts (24).
Note: Make sure holes align on Back and Front Posts.
2. Repeat for the other Posts and Foot.
Back
Post (5)
Front
Post (9)
Bolt
(16)
Spring
Washer
(21)
Nut
(24)
8
Figure B
3. Attach Spreader (7) to Post assembly with
Bolt (17), Spring Washer (21) and Nut (24).
4. Repeat for other Post assembly.
Spring
Washer
(21)
Spreader
(7)
Nut
(24)
Bolt
(17)
Figure C
5. Slide Press Apron (6) over Post assemblies and
secure with Press Apron Support Pins (29).
Press
Apron
(6)
Press Apron
Support
Pins (29)
Figure D
6. Attach Press Pin Guide (14) to Lower Cross Beam (2)
with two sets of Bolts (16), Spring Washers (21)
and Nuts (24). Tighten connections securely.
Press Pin
Guide (14)
Nut
(24)
Bolt
(16)
Lower
Cross
Beam (2)
Spring
Washer
(21)
Figure E
7. Attach other Press Pin Guide to
Upper Cross Beam (4) with two sets
of Bolts (16), Spring Washers (21) and
Nuts (24). Tighten connections securely.
Bolt
(16)
Spring
Washer
(21)
Nut
(24)
Upper Cross
Beam (4)
Figure F