Product manual

Page 6SKU 95826 For technical questions, please call 1-800-444-3353.
Figure 1
17
16
15 14 13
1. Be sure the Handle is NOT attached to an air supply and that the Safety Lever (21)
is locked. Loosen the two Blade Lock Screws (16) located on the Blade Holder (15)
using the Allen Wrench (20). Slide the Scraper Blade you want to remove out of the
slot and insert the Scraper Blade you wish to use. Tighten the Blade Lock Screws
(16) rmly with the Allen Wrench (20). See Figure 1.
Reattach the Air Scraper to the air supply. The Air Scraper is now ready for use.2.
OPERATION INSTRUCTIONS
Unlock the Safety Lever (21). Always carefully check the air pressure by lightly 1.
pressing on the Trigger Arm (7). The air pressure can be regulated by twisting the
Regulator (3) at the rear of the Handle (1). Test the Scraper Blade (17) gently against
the surface you are working with until you have the correct pressure you need.
The speed of the Scraper Blade (17) can be regulated by how much pressure is 2.
exerted on the Trigger Arm (7). The speed increases as you apply downward motion
on the Trigger Arm (7) and decreases as you let the Trigger Arm (7) return to it’s
original position.
Release the Trigger Arm (7) to stop the motion of the Scraper Blade (17). 3.
Use an angle and level that will not gouge the work surface. You may want to test 4.
the Air Scraper against another surface in order not to damage the surface you will
be working with.
Always detach the air supply if when you are nished using the Air Scraper, or if 5.
you will be away from your work for any length of time.
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Air Scraper is unplugged from it’s air supply before
performing any inspection, maintenance, or cleaning procedures.
Note: Always wear safety equipment (see page 3), including work gloves, when using
this tool.
REV 07h