Product manual

Item 61750 For technical questions, please call 1-888-866-5797. Page 9
RUBBER
FOOT
(78)
WASHER
(80)
Bolt
(79)
BOLT (86)
WASHER (87)
FIGURE D
Screw (28)
FIGURE E
To Assemble the Pulleys, Sanding Disc Plate, and Table:
1. Remove the 4 screws from the cover on the Dust Guard (22) and set aside.
2. Line up the three bolt holes on the Dust Guard (22) with the threaded holes in
the End Shield (19). Place a Washer (27) over each of 3 screw holes. Insert a
Screw (28) into each hole and tighten. (See Figure E.)
3. This item is packed with tape on the shafts to
keep the keys in place. Remove the tape
from the upper shaft, being careful to not
lose the key.
4. Loosen the Set Screw (23) on the
Spindle Pulley (24). Put the Spindle
Pulley on the upper shaft, with the
smaller step on the pulley inside and
with the Key (12) lined up with the slot
on the Pulley. Be sure the key stays in
the correct position, all the way through the
pulley.
5. Repeat steps 3 and 4, putting the Motor Pulley (26) on
the lower shaft. (See Figure F.)