Product manual

Item 61750 For technical questions, please call 1-888-866-5797. Page 12
To Install a Sanding Disc:
1. CAUTION: Always turn the Power Switch (64) to its “OFF” position and unplug
the Power Cord (59)
from its 110 volt
electrical outlet
before performing
this procedure.
(See Figure B.)
2. Swing the Table
Support (51) out of
the way and remove
the cover from the
Dust Guard (22)
as explained on
page 9. Check
to make sure the
Sanding Disc
Plate (30) is free of
dirt, oil, and other debris. (See Figure I.)
3. Remove the paper backing on the adhesive Sanding Disc (32), and stick the
Sanding Disc firmly and evenly onto the Sanding Disc Plate (30). Restore the
Table Support and Dust Guard to their original positions. (See Figure I.)
To Adjust the Angle of the Table:
1. The angle of the Work Table (41) may be adjusted from 0 to 45 Degrees. (See
Figure J.)
2. To adjust the angle of the Work Table (41), slightly loosen the Knob (45). (See
Figure J.)
3. Observe the Angle Gauge (42). Then raise or lower the Work Table until the
desired angle of the Work Table is shown on the Angle Gauge. (See Figure J.)
4. Once the desired angle of the Work Table (41) is obtained, retighten the
Knob (45). (See Figure J.)
SANDING DISC PLATE
(30)
SANDING DISC
(32)
FIGURE I