Product manual

Item 61750 For technical questions, please call 1-888-866-5797. Page 11
OPERATING INSTRUCTIONS
To Install A Sanding Belt:
1. CAUTION: Always turn the Power Switch (64) to its “OFF” position and unplug
the Power Cord (59) from its 110 volt electrical outlet before performing this
procedure. (See Figure B.)
2. Loosen the two Knobs (107) in order to unlock the two Adjusting Nuts (108).
(See Figure H, next page.)
3. Turn the two Adjusting Nuts (108) counterclockwise to allow the Sanding Belt (1)
to be inserted onto the Sand Belt Frame (106). (See Figure H.)
4. Slide the Sanding Belt (1) fully and evenly onto the Sanding Belt Frame (106).
Then, turn the two Adjusting Nuts clockwise to tighten the tension on the Sanding
Belt. (See Figure H.)
5. Retighten the two Knobs (107), and lock the two Adjusting Nuts (108) in place.
(See Figure H.)
6. Plug the Power Cord (59) into a 110 volt electrical outlet, and turn the Power
Switch (64) to its “ON” position. (See Figure B.)
7. Allow sufficient time for the Sanding Belt (1) to turn at full speed. (See Figure H.)
8. NOTE: If the Sanding Belt (1) appears to be too loose on the Sand Belt
Frame (106), turn off the machine and unplug it from its electrical outlet. Then
repeat Steps #2 through #7 to further increase the tension on the Sanding Belt.
(See Figures B and H.)
9. Attach the Work Stop (105) to the side of the Sanding Belt Frame (106), as
shown in Figure H.
LOCK KNOB &
ADJUST NUT
ASSY.
(107)
KNOB (107)
ADJUST NUT (108)
SANDING BELT FRAME
(106)
FIGURE H
SANDING BELT (1)
WORK STOP (105)
Sand in this area.