Product manual

Item 6852 For technical questions, please call 1-888-866-5797. PAGE 9
REV04h;05b
Screw (20)
FIGURE E
SCREW (66)
WASHER (65)
RUBBER
FOOT
(59)
WASHER
(60)
SCREW
(61)
SCREW (66)
WASHER (65)
SCREW (66)
WASHER (65)
SCREW (66)
WASHER (65)
FIGURE D
Figure A:
To Assemble the Pulleys, Sanding Disc Plate, and Table:
1. Remove the 4 screws from the cover on the Pulley Cover (22) and set aside.
2. Line up the three bolt holes on the Pulley Cover (22) with the threaded holes
in the Bracket (26). Place a Washer (21) over each of 3 Screws (20). Insert a
Screw (20) into each hole and tighten. (See Figure E.)
3. This item is packed with tape on the shafts to
keep the keys in place. Remove the tape
from the upper shaft, being careful to not
lose the key.
4. Loosen the Set Screw (14) on the
Large Pulley (19). Put the Large
Pulley on the upper shaft, with the
smaller step on the pulley inside and
with the key lined up with the slot on
the Pulley. Be sure the key stays in
the correct position, all the way through the
pulley.
5. Repeat steps 3 and 4 putting the Small Pulley (52) on
the lower shaft. (See Figure F.)