Product manual
Item 6852 For technical questions, please call 1-888-866-5797. PAGE 8
5. To connect the remaining Frame (64) to the two Stands (56), follow Steps #1, #2,
#3, and #4). (See Figure C.)
STAND
(56)
STAND
(56)
FRAME
(64)
FRAME
(64)
BOLT (58)
WASHER (60)
NUT (63)
BOLT (58)
WASHER (60)
NUT (63)
UPPER BRACKET (57)
FIGURE C
UPPER
BRACKET
(57)
(mostly hid-
den)
6. Place both Upper Brackets (57) on the top edges of the two Stands (56), and
align the eight mounting holes (two on each end) of the Brackets with the eight
mounting holes (two on each end) of the Stands. (See Figure C.)
7. Secure both Upper Brackets (57) to the two Stands (56), using eight Bolts (58),
Washers (60), and Nuts (63). (See Figure C.)
8. With assistance, carefully tip the assembled Stand on its side. Attach a Rubber
Foot (59) to each of the Stand’s four corners, using four Rubber Feet, four Wash-
ers (60), and four Screws (61). Then, place the Stand back in its upright position.
(See Figure D.)
To Attach The Base To The Upper Bracket:
1. With assistance, place the Base (51) of the Belt/Disc Sander on top of the Upper
Brackets (57). Align the four threaded mounting holes on the Base with the four
mounting holes on the Upper Brackets. (See Figures B, and D.)
2. From underneath the Stand, secure the Base (51) to the Upper Brackets (57) by
inserting four Screws (66), with four Washers (65), upward through the Stand’s
fourmountingholes.Then,rmlytightenthefourScrewsintothefourthreaded
mounting holes on the Base. (See Figure D.)
REV 05b