Product manual

Item 6852 For technical questions, please call 1-888-866-5797. PAGE 7
PRODUCT FEATURES
NOTE: Prior to assembling and operating the Belt/Disc Sander, it is important to fa-
miliarize yourself with all of the machine’s major components. Failure to do so
may result in personal injury and/or damage to the machine and workpiece being
sanded. (See Figure B, and refer to the “Operating Instructions” section in
this manual.)
9” SANDING DISC
(15)
6” SANDING
BELT (2)
TABLE (1)
MITER GAUGE
(3)
BACK STOP
(39)
POWER
SWITCH
(53)
POWER
CORD
(55)
LOCK KNOB/ADJUST NUT ASSY. (44)
FIGURE B
STAND
(56
FRAME
(64)
BASE
(51)
PULLEY
COVER
(22)
SAND BELT
FRAME (40)
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 17.
To Assemble The Stands, Frames, And Upper Bracket:
1. With assistance,positionthetwoStands(56)uprightontheoorandparallelto
one another. (See Figure C.)
2. Place the end of one Frame (64) on the inside edge of one Stand (56), and align
the two mounting holes on the end of the Frame with the two lower mounting
holes on the Stand. (See Figure C.)
3. Secure the Frame (64) to the Stand (56), using two Bolts (58), two Washers (60),
and two Nuts (63). (See Figure C.)
4. Repeat Steps #1, #2, and #3 to connect the other end of the Frame to the re-
maining Stand. (See Figure C.)