Product manual

Item 6852 For technical questions, please call 1-888-866-5797. PAGE 15
To Perform Horizontal Sanding With The Sanding Belt:
1. CAUTION: Before each use, inspect the condition of the Sanding Belt (2). Look
for tearing, excessive wear, or other damage to the Sanding Belt. Never use a
Sanding Belt that is damaged. When replacing, never use an inexpensive, low
quality Sanding Belt.
2. Plug the Power Cord (55) into a grounded, 110 Volt electrical outlet. (See Fig-
ure B.)
3. Turn the Power Switch (53) to its “ON” position, and allow the Sanding Belt (2) to
come to full speed for approximately ten seconds before feeding the workpiece
into the Sanding Belt. (See Figure B.)
4. Hold the workpiece rmlywithbothhands,andcarefullysetitatandlevelupon
the Sanding Belt (2) and against the Back Stop (39). (See Figure B.)
5. Apply moderate downward pressure on the workpiece, allowing the Sanding
Belt (2) to cut without being forced.
6. Once the sanding procedure is completed, remove the workpiece from the Sand-
ing Belt (2), turn the Power Switch (53) to its “OFF” position, and unplug the
Power Cord (55) from its electrical outlet. (See Figure B.)
SET SCREW
(14)
SET SCREW
(14)
SUPPORT BAR
(18)
SUPPORT
BAR
(18)
TABLE (1)
TABLE
(1)
SANDING BELT FRAME
(40)
END VIEW SIDE
VIEW
FIGURE M
SANDING
BELT
(2)
REV 04b