Product manual
Item 6852 For technical questions, please call 1-888-866-5797. PAGE 14
To Adjust The Sand Belt Frame For Vertical Sanding:
Loosen the two Nuts (36) on the Sanding Belt Frame (40), and with assistance
raise the Sanding Belt Frame to its full verticalposition.Then,rmlyretightenthe
two Nuts to lock the Sanding Belt Frame in place. (See Figure L.)
To Adjust The Position Of The Table:
1. When the Sanding Belt Frame (40) is in its vertical position, the Table (1) should be
repositioned to the front of the Sanding Belt Frame. (See Figure M, next page.)
2. To reposition the Table (1), loosen the two Set Screws (14) and remove the Table,
including the Support Bar (18). (See Figure M.)
3. Insert the Support Bar into the Mounting Hole, and tighten the other two Set
Screws (14). (See Figure M.)
4. NOTE: When repositioning the Table (1), make sure there is more than
1
/
16
” clear-
ance but less than
1
/
8
” clearance between the Table and the Sanding Belt Frame
(40). (See Figure M.)
NUT (36)
SANDING BELT FRAME (40)
(VERTICAL POSITION)
FIGURE L
REV 04b