Product manual
Item 6852 For technical questions, please call 1-888-866-5797. PAGE 12
To Install A Sanding Disc:
1. CAUTION: Always turn the Power Switch (53) to its “OFF” position and unplug
the Power Cord (55) from its 110 volt electrical outlet before performing this
procedure. (See
Figure B.)
2. Swing the Table
Support Bracket
(9) out of the way
and remove the
cover from the
Pulley Cover ( 22)
as explained on
page 9. Check
to make sure the
Sanding Disc
Plate (16) is free
of dirt, oil, and
other debris. (See
Figure I.)
3. Remove the paper backing on the adhesive Sanding Disc (15), and stick the
SandingDiscrmlyandevenlyontotheSandingDiscPlate(16).Restore
the Table Support Bracket and Pulley Cover to their original positions. (See
Figure I.)
To Adjust The Angle Of The Table:
1. The angle of the Table (1) may be adjusted from 0 to 45 Degrees. (See Fig-
ure J.)
2. To adjust the angle of the Table (1), slightly loosen the Knob (10). (See Figure J.)
3. Observe the Angle Gauge (5). Then raise or lower the Table until the desired
angle of the Table is shown on the Angle Gauge. (See Figure J.)
4. Once the desired angle of the Table (1) is obtained, retighten the Knob (10).
(See Figure J.)
SANDING DISC PLATE
(16)
SANDING DISC
(15)
FIGURE I
REV 04b