Product manual
Item 6852 For technical questions, please call 1-888-866-5797. PAGE 11
OPERATING INSTRUCTIONS
To Install A Sanding Belt:
1. CAUTION: Always turn the Power Switch (53) to its “OFF” position and unplug the
Power Cord (55) from its 110 volt electrical outlet before performing this procedure.
(See Figure B.)
2. Loosen the two Lock Knobs (44) in order to unlock the two Adjust Nuts (44). (See
Figure H, next page.)
3. Turn the two Adjust Nuts (44) counterclockwise to allow the Sanding Belt (2) to be
inserted onto the Sand Belt Frame (40). (See Figure H.)
4. Slide the Sanding Belt (2) fully and evenly onto the Sanding Belt Frame (40). Then,
turn the two Adjust Nuts clockwise to tighten the tension on the Sanding Belt. (See
Figure H.)
5. Retighten the two Lock Knobs (44), and lock the two Adjust Nuts (44) in place. (See
Figure H.)
6. Plug the Power Cord (55) into a 110 volt electrical outlet, and turn the Power
Switch (53) to its “ON” position. (See Figure B.)
7. AllowsufcienttimefortheSandingBelt(2)toturnatfullspeed.(See Figure H.)
8. NOTE: If the Sanding Belt (2) appears to be too loose on the Sand Belt Frame (40),
turn off the machine and unplug it from its electrical outlet. Then repeat Steps #2
through #7 to further increase the tension on the Sanding Belt. (See Figures B
and H.)
9. Attach the Back Stop (39) to the side of the Sanding Belt Frame (40), as shown in
Figure H.
LOCK KNOB &
ADJUST NUT ASSY.
(44)
LOCK KNOB &
ADJUST NUT ASSY (44)
LOCK
KNOB (44)
ADJUST NUT (44)
SANDING BELT FRAME
(40)
FIGURE H
SANDING BELT (2)
BACK STOP (39)
Sand in this area.
REV 04b