Product manual

Item 6852 For technical questions, please call 1-888-866-5797. PAGE 10
6. Carefully align both pulleys and tighten.
Useaatheadscrewdriverthroughthe
slot in the Pulley Cover (22) to tighten
the Set Screw (14) on the Large Pulley
(19). (See Figure G.) Use a hex key (not
included) to tighten the Set Screw (14) on the Small
Pulley (52).
7. Loosen the 4 Screws (48) that hold the Motor (30)
just enough to let the Motor move. Move the Motor
towards the Large Pulley enough to let the Belt (17)
slip on over both Pulleys. Move the Motor away from the Large Pulley until the
Belt is tight enough so that, if pushed, it doesn’t move more than
1
/
2
”. Hold the
Motor in place while you retighten the 4 Screws (48).
8. PuttheSandingDiscPlate(16)ontheendoftheshaftsothatit’sushwiththe
end of the shaft. Tighten its set screw, once again using the slot in the Pulley
Cover (22). (See Figure G.)
9. Check to make sure the Sanding Disc Plate (16) is free of dirt, oil, and other
debris.
10. Remove the paper backing on the adhesive
Sanding Disc (15), and stick the Sanding Disc
rmlyandevenlyontotheSandingDiscPlate
(16). (See Figure I, page 11.)
11. Replace cover of the Pulley Cover (22) and
tighten the 4 screws. Verify that the pulley cover
does not contact the Sanding Disc
(15). If it does, you need to adjust
the Sanding Disc Plate (16).
NOTE: When positioning the Table (1), make sure there is more than
1
/
16
” clearance but
less than
1
/
8
” clearance between the Table and the Sanding Disc (15).
12. Insert the round end of the Support Bar (18) into the hole on the side of the
Base (18). (See Figure G.) Put the Table Support Bracket (9) over the end of
the Support Bar, with the tapered side of the Bracket facing the Sanding Disc
(15)andalsotheatsideoftheBarlinedupwiththeSetScrew.Tightenthe
Set Screw (14) on the Table Support Bracket. Set the Table Support Bracket as
shown in Figure J, page 12. Tighten the two Set Screws (14) on the side of the
Base to secure the bar.
FIGURE G
Hole for Support Bar (18)
FIGURE F
Large Pul-
ley (19)
Small Pul-
ley (52)
REV 04b