Product manual

Page 7For technical questions, please call 1-800-444-3353.SKU 32997
Step 3: Insert the material to be clamped. If the material is small, place it over
one of the runners of the UPPER BASE (20) as shown in Figure 4.
This will keep the material from falling below into the Vise.
U pper Base
(#20)
P la c e s m a ll m a te r ia l
over runner
(20)
Figure 4 -- Placing Small Material
Step 4: Begin to close the SLIDE (24) by turning the LEAD SCREW
(21). This will tighten the Jaws of the Vise.
Step 5: When the SLIDE (24) touches the material you are working on, tighten the SLIDE (24)
only enough to ensure clamping. DO NOT CRUSH the material you are working on.
CAUTION
Do Not Over Tighten the
Vise. You Will Damage
Your Material.