Product manual

Page 7SKU 94696 For technical questions, please call 1-800-444-3353.
18. Before every tow, check all towing equipment. Repair or replace any damaged
equipment. When towing over a long distance recheck all equipment at short, regular
intervals. Make sure to check tire ination for both the towing vehicle and towed vehicle.
19. Drive safely. When the weight of a towed vehicle is coupled to a towing vehicle, the
effect of the additional weight will diminish the performance of the towing vehicle,
resulting in decreased acceleration of the towing vehicle and increased stopping
distances. The added weight will also cause an adverse affect on the towing vehicle’s
handling characteristics. Always reduce speed when towing a vehicle.
20. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors, which
cannot be built into this product, but must be supplied by the operator.
ASSEMBLY INSTRUCTIONS
NOTE: Most vehicles will require an after market mounting bracket assembly (not
included), which then connects to the Tow Bar (see photos on page 2). Installing after-
market mounting bracket assembly should be done by a qualied auto technician.
NOTE: On some vehicles the included Mounting Brackets (8A) can be bolted directly to frame
or bumper. Instructions below cover the assembly and set up of the Tow Bar in these instances.
1. Loosen the two Bolts (3B), and spread apart the Right Arm (4A) and Left Arm (5A).
(See Figure A.)
2. On the Right Arm (4A) and Left Arm (5A), unscrew the Lock Nuts (6B) and remove the
Bolt (5B). Then slide the Mounting Brackets (8A) off the Right and Left Arms.
(See Figure A.)
3. Select two locations in the front of the vehicle to be towed that t ALL of the following
criteria:
A. Can adequately support the entire towing weight of the vehicle without damage to the
vehicle.
B. Have less than 5/8” mounting surface thickness, and can each support two
REV 07a, 10b