Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 69159
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If damaged or loose parts are noted,
have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for loose
hardware, misalignment or binding of moving
parts, cracked or broken parts, and any other
condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Keep the moving parts oiled, being sure to wipe
off any excess oil off of the Handle and Jaws.
4. Check and tighten the mounting screws
to be sure the Vise is secure.
5. Replacing a Jaw Plate (2):
a. Unscrew the Screws holding
the Jaw and set aside.
b. Replace with a new Jaw and securing
in place with the Screws. Tighten.
c. Repeat on the other Jaws if
necessary. See Figure 6.
Figure 6
Jaw Plate (2)