Product manual

Page 3For technical questions, please call 1-800-444-3353.SKU 90582
18. Keep bystanders away during use.
19. Avoid burns. Allow the engine oil to completely
cool before draining the oil into the Drain.
20. Do not leave unattended when
operating or evacuating oil.
21. Remove the Drain before lowering the vehicle.
22. Recycle used oil according to regulations.
23. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
Specications
Tank Capacity 5 Gallons
Height 40″ – 67″
Assembly
Read the ENTIRE IMPORTANT
SAFETY INSTRUCTIONS section at
the beginning of this manual before
set up or use of this product.
1. Screw the Funnel (1) onto the threaded
portion of the Upper Tube (2).
2. Insert the Upper Tube into the Lower Tube (4).
3. Screw the two Wing Screws (3) into the two threaded
holes located at the top portion of the Lower Tube (4).
4. Screw the threaded portion of the Lower
Tube (4) into the top of the Tank (6).
5. Place the Strap (7) around the lower portion of the
Tank (6), and secure the Strap to the Tank using one
Bolt (11), one Lock Washer (12), and one Nut (13).
6. Insert the threaded portion of the four Casters (10)
upward into the four mounting holes located on
the Strap (7), and secure the Casters to the Strap
using four Lock Washers (9) and four Nuts (8).
Operation
Read the ENTIRE IMPORTANT
SAFETY INSTRUCTIONS section at
the beginning of this manual before
set up or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
1. Loosen the two Wing Screws (3) slightly
and slide the Funnel (1) and Upper Tube (2)
downward to lowest position.
2. Move the Drain under the raised vehicle, and position
the Funnel (1) directly below the oil drain plug.
3. Raise the Upper Tube (2) and Funnel (1) until the
Funnel is approximately 4″ below the oil drain plug.
Then, tighten the two Wing Screws (3) to
hold the Upper Tube and Funnel in place.
4. Remove the oil drain plug, and allow the used oil to
completely drain from the engine into the Funnel (1).
Note: Do not exceed 5 gallon capacity.
5. Once the used engine oil is completely drained,
replace the oil drain plug.
6. Loosen the two Wing Screws (3) slightly,
and slide the Upper Tube (2) and Funnel (1)
downward to the lowest position.
7. Move the Drain out from under the vehicle.
8. When emptying the oil from the Tank (6),
follow guidelines for engine oil recycling.
User-Maintenance Instructions
 Proceduresnotspecicallyexplained
in this manual must be performed
onlybyaqualiedtechnician.
1. Before each use, inspect the general condition of
the Drain. Check for broken or bent parts, loose
or missing parts, and any condition that may
affect the proper operation of the product. If a
problem occurs, have the problem corrected before
further use. Do not use damaged equipment.
2. After each use, clean the Drain of any
spilled oil, using a detergent or mild solvent.
3. Store in a safe and dry location.