QUICK ACTION 8-POSITION WORKBENCH 47078 ASSEMBLY & OPERATING INSTRUCTIONS ® 3
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model___________ Serial No._____________ Purchase Date_____________ Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover.
8. Use eye and ear protection. Always wear ANSI approved impact safety goggles. 9. Do not exceed products maximum load capacity. Make certain that the Workbench can support all tools and accessories, as well as any workpiece. 10. Avoid Sharp edges when assembling. 11. Always check hardware and assembled parts after assembling. Place in an area that is flat and level. All connections should be tight and hardware tightened. 12. Do not allow children to play on, stand upon or climb upon the Workbench.
Figure 2 Washer (#15) with Hex Nut (#14) U-Frame Channel (#10) Hex Nut (#18) Washer (#19) Cross Head Bolt (#16) Grip (#28) Hex Bolt (#29) Washer (#19) Hex Nut (#18) Step 5) Through the center hole in the extension, insert Hex Bolt (#29), slide on Washer (#19) and fasten with Nut (#18)-see Figure 2. Step 6) Set the U-Frame Channel (#10) on top of the Right Leg Stand Frame (#27) as shown in Figure 2.
Step 9) Lay the Table Top Back (#6) on top of the Connecting Parts (#7). Through the inside hole, insert Cross Head Bolt (#3) with Washer (#4) so that it threads down through the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking Block (#13). Step 10) Through the outside holes in the Table Top Back (#6), thread the Push Button (#2) into the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking Block (#12).
Unpacking When unpacking your Quick Action 8-Position Workbench, check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.
Parts/Assembly Diagram 21 7A 21 7A #47078 REV 01/05 Page 7
