CAR CANOPY ASSEMBLY INFORMATION ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at http://www.harborfreight.com Copyright © 2001 by Harbor Freight Tools. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
SPECIFICATIONS ITEM DESCRIPTION Weight 152.80 Lbs. Canopy Base Dimensions 20’ 8-1/2” L x 20’ 6” W Center Height 10’ Side Height 69-1/4” Frame Width 18’ 1” Pole Tubing Diameter 1-1/4” Connector Diameter 1-1/2” SAVE THIS MANUAL You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover.
6. DO NOT OVERREACH. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etcetera. 7. MAINTAIN A SAFE WORK ENVIRONMENT. Keep work area well lit. Make sure there is adequate surrounding work space. 8. CHECK FOR DAMAGED PARTS. Before using this product, check for damaged parts and any other conditions that may affect the operation of the Canopy. Replace or repair damaged or worn parts immediately. 9. REPLACEMENT PARTS AND ACCESSORIES.
ASSEMBLY INSTRUCTIONS ALL PARTS BELOW REFER TO THE PARTS SHOWN ON PAGE 6. Note: To insure safe assembly of this product, two people should assemble the Car Canopy. 1. Connect the assorted Tubes and Swaged Tubes (parts #2, 3, 4, 5, 6, 7), 3-Way End Pieces (part #8), and 4-Way Center Pieces (part #9) together as shown in Figure A. FIGURE A 2. The eight Turnbuckles (part #11) are used to strengthen the frame assembly. Attach the Turnbuckles to the frame assembly and tighten, using a pair of pliers.
3. Drape the Tarp (part #14) over the assembled frame and secure the corners of the Tarp onto the frame, by inserting the Tarp Ties (part #10) through the metal eyelets of the Tarp and around the framing Tubes as shown in Figures C and D. 4. Once the corners are fastened, attach the remaining Ball Bungies through the rest of the metal eyelets and onto the framing Tubes. FIGURE C Tarp Ties (#10) Caution: The Car Canopy must be firmly secured on a flat, level and solid surface. FIGURE D 5.
and any other condition that may affect its safe operation. Do not use damaged equipment. 2. Keep this Canopy free of oil, grease, liquids, dirt, and other debris. Use only a mild detergent and damp cloth when cleaning. Never use flammable or combustible liquids to clean the Canopy. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY.
