Product manual

Page 10 For technical questions, please call 1-800-444-3353. Item 69236
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Tool Set Up: Chisel Installation
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specically explained within this manual.
Improper adjustment can result in tool failure or other serious hazards.
TO PREVENT INJURY:
Wear heavy-duty work gloves during Chisel installation.
1. Place the air intake end of the tool on a
clean surface on the oor. This will prevent
debris from entering into the air intake.
2. Pull down on Collar (24), making sure to keep the
open end of Retaining Ring (25) between your thumb
and index nger to prevent pinching.
3. Position end of the Chisel (26) into Chisel Holder (19)
and rotate Chisel until it slides in. See Figure A.
Figure A
Collar (24)
Chisel Holder (19)
Chisel (26)
4. Release the Collar to lock Chisel in place.