Saw User Manual

Making a Circle Cut.
1. Assemble the circle cutter assembly onto the tool as
previously discussed.
2. On the tile, mark the center point of the circle, and measure
or mark the circumference of the intended circle cut.
3. Squeeze the Press Handle (#A) downward, lifting the drill
point and knife body above the level of the cutter base.
4. Place the tile on the EVA cushion, with the centerpoint of the
circle directly under the center drill of the circle cutter.
Release the Press Handle slowly, and adjust the tile to
carefully align the Triangle Drill (#G) with the enter point of
the hole marked on your tile.
5. Loosen the nut on the Knife Body (#F), and slide the
knife body until the knife point aligns with the circumference
you have marked on the tile. Retighten the nut.
6. Holding the tile firmly onto the EVA Cushion, rotate the
Crank (#B) clockwise to drill into the tile, and cut
the circle. Continue rotating the crank until the circle has
been completely cut through the tile.
Page 7 SKU # 41711
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY: NEITHER THE
MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND
TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT: IN FACT THE MANUFACTURER
A ND/OR DISTRIBUTOR EXPRESSLY STATES
THATALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER IN-
STALLATION OF REPLACEMENT PARTS THERETO.
Figure 6. Adjusting the Circle Scale.
Figure 7. Locating the Tile Before
Releasing the Press Handle.
Figure 8. Turning the Crank to
Cut a Circle Hole.