Saw User Manual
Page 5 SKU # 41711
ASSEMBLY
Your Tile Cutter is mostly assembled when you receive it. Please complete the assembly as follows.
Install the Bottom Feet.
1. Slide each Bottom Foot (#T) onto the lower corners of
the Base (#V). Attach each one with the bolts, nuts, and
washers supplied. Tighten the fasteners firmly.
Install the Circle Cutter.
Your tile cutter comes set up for making straight cuts.
Whenever you wish to make circle cuts, you must install the
circle cutter. Remove the circle cutter when finished.
1. Raise the Handle (#H) and slide the mechanism away
from the circle cutter area towards the Buffer Sleeves (#L).
2. Remove the nut and washer from the Pressing Plate (#E),
be careful not to lose these parts.
3. Place the circle cutter mechanism onto the Tracks (#M)
with the Press Handle (#A) pointed to the right, away
from the Buffer Sleeve portion of the tool. Align the drill
point of the circle cutter with the center of the hole in the
Base.
4. Place the Pressing Plate (#E) under the tracks and circle
cutter assembly, with the threaded rod inserted upward
through the hole in the base of the circle cutting assembly.
Re-install the nut and washer and tighten.
Install the try square.
Depending on the model you purchased, the try
square may install with the arm extension of the try square
either to the front of the tool, or to the rear. Both versions
work equally well. The measuring scales on your tool also
may be marked either in millimeters or inches.
1. Position the try square (#U) with the molded-in scale
markings upward. Place the slotted arm of the try square
over the guide on the base of the tool. Secure the try
square in place with the Wing Nut (#Q).
OPERATION
The basic cutting operation is accomplished by scoring the tile in the desired location, and break-
ing it. This process is similar to scoring and cutting glass.
NOTE: It’s a good idea to make a few practice cuts on your tile before attempting to make finish cuts.
Use a sturdy workbench, or else place the machine on the floor to increase your leverage.
Figure 1. Foot Assembly.
Figure 2. Hole Cutter Assembly.