Product manual

Page 3SKU 30999 For technical questions, please call 1-800-444-3353.
5. The warnings, precautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Overall Length 6-1/2 IN.
Overall Width 8-3/4 IN.
MOUNTING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including all
text under subheadings therein before
set up or use of this product.
Note: For additional information regarding
the parts listed, refer to the Assembly
Diagram near the end of this manual.
1. Vise must be mounted on a solid,
level surface capable of supporting
combined weight of Vise, intended
workpieces, and applicable forces.
2. Use the holes in the base of the Vise as a
template to mark the bench surface. Verify
that the installation surface has no hidden
utility lines before drilling or driving screws.
3. Drill 1/2” wide holes and attach the
Vise rmly to the work surface with
appropriate hardware (1/2” lug bolts or
hexagonal bolts, at washers, and self
locking hex nuts, all sold separately).
4. Properly mount the Drill Press Vise to
workbench or other work surface.
OPERATION
1. Turn Lock Bar to open Jaws and place
workpiece between the jaws.
2. Close the Jaws until the workpiece is held
securely. Do not overtighten the Jaws.
Overtightening the Jaws could damage the
workpiece. Use soft jaws when necessary
to prevent damage to the workpiece.
The orientation of the Jaws will become
xed after the handle is tightened.
MAINTENANCE AND
SERVICING
Procedures not specically explained
in this manual must be performed
only by a qualied technician.
1. BEFORE EACH USE, inspect the
general condition of the tool. Check for
misalignment or binding of moving parts,
cracked or broken parts and any other
condition that may affect its safe operation.
2. AFTER USE, clean external surfaces
of the tool with clean cloth.
3. Lubricate the moving parts of the Vise
periodically with a high quality machine oil.
4. In moderate to extensive use or when
foreign particles accumulate on the Jaws,
take the Vise apart and thoroughly clean all
components,
re-assemble and properly lubricate.
Replacing the Jaws
1. To replace Jaws, insert a screwdriver or
wrench to remove the securing screws.
2. For added security, attach and tighten
the new jaws with the same screws.
Record Product’s Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
Note: Replacement parts are not available.
REV 11f