Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 61826
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this manual including all text
under subheadings therein before
set up or use of this product.
Tool Set Up
TO PREVENT INJURY FROM
ACCIDENTAL OPERATION:
Release the Trigger and disconnect Power Adapter
before adjusting tool or installing accessories.
Charging Battery
1. Insert the Adapter cord plug into the
back of the Screwdriver’s housing.
2. Plug the Adapter module into an electrical
outlet. The red Charging Indicator will
light. Charge up to 5-7 hours.
3. Remove the Adapter from the electrical outlet. The red
Charging indicator will turn off.
CAUTION! Do not overcharge the Battery. Do
not charger for more than 7 hours continuously.
The Adapter should not be left connected after
charging is complete during operation.
General Operating Instructions
TO PREVENT INJURY FROM
ACCIDENTAL OPERATION:
Release the Trigger and disconnect Adapter
prior to making any adjustments to the tool.
1. Disconnect the Power Adapter before operation.
The Screwdriver is designed to accept a 1/4”
standard hex driver. Do not use larger drivers as
damage to the gears and/or motor may result.
2. Snap the desired hex driver into the Magnetic Chuck.
3. If light is needed while driving screws, turn on
the Work Light using the Work Light Switch.
NOTE: The Work Light will activate once the
Forward or Reverse Trigger is pressed.
4. Engage the Screwdriver bit over the item being turned.
The bit size must match the size of the screw.
5. Squeeze and hold down the top Forward Trigger to
start clockwise rotation. For reverse (counterclockwise)
rotation, squeeze the bottom Reverse Trigger.
6. When nished using the Screwdriver, release the
Forward / Reverse Trigger to turn off the tool.
7. Clean then store the Screwdriver indoors
and out of children’s reach.