Product manual
Page 9For technical questions, please call 1-800-444-3353.SKU 67996
Coupler of an hose (not included) onto
the Quick Connector.
WARNING! TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL
OPERATION: Do not install a female
quick coupler on the tool. Such a
coupler contains an air valve that will
allow the air tool to retain pressure and
operate accidentally after the air supply
is disconnected.
Note:
performance, can be hindered by
undersized air supply components.
The air hose must be long enough to 3.
reach work area with enough extra
length to allow free movement while
working.
Make sure tool’s throttle or switch is 4.
in the off position; refer to Operation
section for description of controls.
5.
the compressor and the tool.
Turn on air compressor according to 6.
manufacturer’s directions and allow it to
build up pressure until it cycles off.
7.
so that air output is enough to properly
power the tool, but the output will not
exceed the tool’s maximum air pressure
gradually, while checking the air output
gauge to set the right pressure range.
Inspect air connections for leaks. Repair 8.
any leaks found.
If tool will not be used at this time, 9.
turn off and detach air supply, safely
discharge any residual air pressure, and
release throttle to prevent accidental
operation.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion after
disconnecting to ensure that the tool is
disconnected and unpowered.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn the Power
Switch of the tool off and unplug
the tool from its electrical outlet
before installing accessories.
Installing the 3” Cutting Wheel
The Cutting Wheel MUST be:1.
rated to at least 18,000 RPM.
arbor hole.
dry and clean.
proven undamaged by inspection.
TO PREVENT
SERIOUS INJURY:
Do not operate this tool without
the Wheel Guard properly
installed.