Product manual
Page 4For technical questions, please call 1-800-444-3353.SKU 67996
and specications provided with this
air tool. Failure to follow all instructions
listed below may result in electric shock,
Operations such as grinding, sanding, 2.
wire brushing or polishing are not
recommended to be performed with
this air tool. Operations for which the
air tool was not designed may create a
Do not use accessories which 3.
are not specically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your air
tool, it does not assure safe operation.
The rated speed of the accessory 4.
must be at least equal to the
maximum speed marked on the air
tool. Accessories running faster than
apart. Use only 3” Cutting Discs rated at
18,000 RPM and greater.
The outside diameter and the 5.
thickness of your accessory must
be within the capacity rating of your
air tool. Incorrectly sized accessories
cannot be adequately guarded or
controlled.
The arbor size of wheels, anges, 6.
backing pads or any other accessory
must properly t the spindle of the air
tool. Accessories with arbor holes that
do not match the mounting hardware
of the air tool will run out of balance,
vibrate excessively and may cause loss
of control.
Do not use a damaged accessory. 7.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear, wire
brush for loose or cracked wires. If air
tool or accessory is dropped, inspect
for damage or install an undamaged
accessory. After inspecting and
installing an accessory, position
yourself and bystanders away from
the plane of the rotating accessory
and run the air tool at maximum no-
load speed for one minute. Damaged
accessories will normally break apart
during this test time.
Wear personal protective equipment. 8.
Depending on application, use face
shield, safety goggles or safety
glasses. As appropriate, wear dust
mask, hearing protectors, gloves
and workshop apron capable of
stopping small abrasive or work piece
fragments. The eye protection must
be capable of stopping ying debris
generated by various operations.
The eye protection must be capable
various operations. The dust mask or
particles generated by your operation.
Prolonged exposure to high intensity
noise may cause hearing loss.
Keep bystanders a safe distance away 9.
from work area. Anyone entering
the work area must wear personal
protective equipment. Fragments of
work piece or of a broken accessory
immediate area of operation.
Risk of Electric Shock. This tool is not 10.
provided with an insulated gripping
surface.
Never lay the air tool down until the 11.
accessory has come to a complete
stop. The spinning accessory may grab
the surface and pull the air tool out of
your control.