Product manual

Page 11For technical questions, please call 1-800-444-3353.SKU 67996
Set the compressor to 90 PSI. 5. Do not
exceed 90 PSI.
6.
explained in the Air Supply section.
Mark area on workpiece you wish to cut.7.
Grip Housing (3) and press down on 8.

forward. WARNING! Use both hands to
grip the Cut-Off Tool.
9.
seconds before approaching workpiece.
NOTE: 10. 
variable. Pressing down on Trigger will
increase Tool’s speed. Easing back on
Trigger will decrease Tool’s speed. Use
only enough speed as needed to cut the
workpiece.
Carefully press the edge of the Cutting 11.
Wheel onto the surface of the workpiece.
WARNING! 12. Do not force, or apply undo
pressure, onto Tool. Applying too much
force will stall the Tool.
If tool requires more force to accomplish 13.
the task, verify that tool receives

and increase air pressure (PSI).
CAUTION! TO PREVENT TOOL AND
ACCESSORY FAILURE, RESULTING
IN INJURY: Do not exceed the tool’s
maximum air pressure rating. If the


then a larger tool may be required.
To prevent accidents, detach air 14.
supply, safely discharge any residual
air pressure in the tool, and release
the throttle after use. Clean external
surfaces of the tool with clean, dry
cloth. Then store the tool indoors out of
children’s reach.