Product manual

Page 10For technical questions, please call 1-800-444-3353.SKU 67996
Use Spanner (44) to hold Spindle (35) in 2.
place while, at the same time, loosening
the Hex Bolt (41) and Flange (40) with
Hex Key Wrench (45). See Figure 1,
below.
Insert 3” Cutting Wheel onto Spindle, 3.
using Spanner to hold Spindle in place.
Insert the Hex Bolt through the Washer 4.
(40) and the Cutting Wheel, and back
into the Spindle.
Use the Hex Key Wrench (45) to tighten 5.
the Hex Bolt on the Spindle until the
Cutting Wheel is secure.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.

access by children or pets to prevent

Route the air hose along a safe route to 2.
reach the work area without creating a
tripping hazard or exposing the air hose
to possible damage. The air hose must
be long enough to reach the work area
with enough extra length to allow free
movement while working.
Secure loose workpieces using a vise 3.
or clamps (not included) to prevent
movement while working.
4.

nearby that will present a hazard while
working.
General Operating Instructions
If an automatic oiler is not used, 1. add a
few drops of Pneumatic Tool Oil to airline
connection before use. Add a few drops
more after each hour of continual use.
Always check the Cutting Wheel (39) 2.
for possible wear. Do not use a worn,
cracked, or defective cutting wheel.
3.
attached Wheel Guard (38) is in position
between you and the workpiece to

The Wheel Guard must always be 4.

Wheel Guard
(38)
Cutting Wheel (39)
Washer (40)
Screw (41)
Figure 1
Trigger (4)

Male
Quick
Connector
(not included)
Air
Inlet (2)
Spindle
(35)