Product manual

Item 98751 For technical questions, please call 1-888-866-5797. Page 12
Operating Nailer
Set proper angle of the Nailer for your
application (a three step process):
Failure to properly
adjust the nailer
can result in tool failure or damage.
Angle Adjustment Holes
Tab (75)
21
o
28
o
34
o
Hex
Bolt
Figure 3
1. Pull back and engage the Tab
(75), exposing three adjustment
holes. Loosen the hex bolt and
slide it into the appropriate hole
(21°, 28°, 34°). Retighten the hex
bolt securely, making sure it fits
into the appropriate hole properly.
See Figure 3, above.
Gently release the Tab.
Adjuster Knob (85)
Figure 4
2. Remove the Adjuster Knob
(85). See Figure 4, above.
Figure 5
34
o
28
o
21
o
Joint Plate (86)
3. Move Magazine so desired
hole on Joint Plate (86) lines
up with the nut on Magazine.
See Figure 5, above. Replace
and tighten the Adjuster Knob.
4. Inspect Pin’s (34) location.
See Figure 6, below.
If you are driving 21° angle nails,
the Pin should be in the lower hole
(position A). If you are driving 28°
Figure 6
Position A
(Pin in 21° Slot)
Position B
(Pin in 28° / 34° Slot)
Pin (34)
21
o
21
o
28
o
/ 34°
28
o
/ 34°
Pin (34)