Product manual

Item 98751 For technical questions, please call 1-888-866-5797. Page 11
Safety Nosepiece (42)
Magazine (79)
Trigger (59)
Air Coupler (95)
Figure 1
3. The Nailer should not fire if Safety
Nosepiece (42) is not depressed
against the workpiece.
4. Make sure Trigger (59) and Safety
Nosepiece (42) move freely,
without sticking. Do not use
nailer if Trigger or Safety sticks.
5. Connect air supply to the Air
Coupler (95). Set the regulator at
the recommended 70 to 120 PSI.
6. Test by depressing Safety Nosepiece
(42) against the workpiece without
pulling the Trigger. The Tool must
not cycle (fire). If it cycles (fires),
stop immediately and have it repaired
by a qualified service technician.
7. Hold tool away or off of workpiece.
The Safety Nosepiece should return
to its original position. Squeeze
Trigger. The tool should not
cycle (fire). If the tool fires, stop
immediately and have it repaired
by a qualified service technician.
8. Depress Safety Nosepiece against
workpiece and squeeze Trigger.
The tool must cycle (fire) only
once. Release the Trigger and
squeeze it again. The tool must
not cycle (fire). With the Trigger
held, carefully lift the Nailer and
press it against the workpiece again.
The tool must not cycle (fire).
If it fails to perform in the manner
explained in bold, have it repaired
by a qualified service technician.
WARNING! Disconnect the
Nailer from the air compressor
whenever loading or servicing.
WEAR ANSI-APPROVED IMPACT
SAFETY GOGGLES WHEN
RELOADING OR DOING ANY OTHER
MAINTENANCE ON NAILER. Other
people in work area must also wear
ANSI-approved safety goggles.
Loading Nails
Tab (75)
Lock (88)
Figure 2
1. Slide the Tab (75) back and
the Lock (88) will hold it in
place. See Figure 2, above.
2. Load a stick of nails (not included)
into the top slot, making sure
nail heads are facing up.
3. Be Careful. When Lock is released,
the Tab will automatically and
forcefully slide forward. Keep your
fingers clear when releasing Lock.
4. Note: The Nailer may not work if
there are only a few nails left in the
tool. If there are only a few nails
remaining, simply load another strip
of nails into the Magazine behind
the few remaining nails and the
Nailer will be ready for further use.