Product manual

Item 98751 For technical questions, please call 1-888-866-5797. Page 10
3. The air hose must be long
enough to reach the work area
with enough extra length to allow
free movement while working.
4. Close the in-line safety valve
between the compressor and the tool.
5. Turn on the air compressor
according to the manufacturer’s
directions and allow it to build
up pressure until it cycles off.
6. Adjust the air compressor’s output
regulator so that the air output is
enough to properly power the tool,
but the output will not exceed the
tool’s maximum air pressure at any
time. Adjust the pressure gradually,
while checking the air output gauge
to set the right pressure range.
7. Inspect the air connections for
leaks. Repair any leaks found.
8. If the tool will not be used at this
time, turn off and detach the
air supply and safely discharge
any residual air pressure.
Note: Residual air pressure should not
be present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
Operation
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before
set up or use of this product.
Inspect tool before use,
looking for damaged, loose,
and missing parts. If any
problems are found, do not
use tool until repaired.
Testing the Full Sequential
Safety Trip Mechanism
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Detach the air
supply, safely discharge any
residual air pressure in the
tool before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY: Do not adjust or
tamper with any control
or component in a way
not specifically explained
within this manual.
Improper adjustment can
result in tool failure or
other serious hazards.
1. WARNING! Even though
the Nailer should be empty
during this procedure, ALWAYS
point the Nailer at a piece of
scrap wood when testing.
2. Completely empty Magazine (79).