Product manual

Page9For technical questions, please call 1-800-444-3353.Item61176
SAFETYOPERATIONMAINTENANCE SETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE,inspectthegeneral
conditionofthetool.Checkfor:
• loosehardware,
• misalignmentorbindingofmovingparts,
• crackedorbrokenparts,
• damagedelectricalwiring,and
• anyotherconditionthatmay
affectitssafeoperation.
2. AFTER USE,wipeexternalsurfaces
ofthetoolwithcleancloth.
3. WARNING! If the supply cord
of this power tool is damaged,
it must be replaced only by a
qualified service technician.
Troubleshooting
Problem Possible Causes Likely Solutions
Toolwillnotstart. 1. Cordnotconnected.
2. Nopoweratoutlet.


3. Internaldamage
orwear.
(Carbonbrushesor
switch,forexample.)
1. Checkthatcordispluggedin.
2. Checkpoweratoutlet.Ifoutletisunpowered,
turnofftoolandcheckcircuitbreaker.
Ifbreakeristripped,makesurecircuitisright
capacityfortoolandcircuithasnootherloads.
3. Havetechnicianservicetool.
Tooloperates
slowlyor
overheats.
Extensioncordtoolong
orwiresizetoosmall.
Eliminateuseofextensioncord.
Ifanextensioncordisneeded,useshorter/
heaviergaugecord.SeeExtension Cords
inGroundingsectiononpage5.
Excessivenoise
orrattling.
Internaldamageorwear.
(Carbonbrushesor
bearings,forexample.)
Havetechnicianservicetool.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.