Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 98179
SPECIFICATIONS
Electrical Requirements
120 VAC / 60 Hz /
4.1 A
Motor Speed n
0
0-1500/min
Chuck Size 3/8 Inch
Chuck Type Keyless Chuck
90SM
E194601
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please call
Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
INSTRUCTIONS FOR PUTTING
INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at
the beginning of this manual
including all text under subheadings
therein before set up or use of this
product.
TO PREVENT SERIOUS
INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to
its “OFF” position and unplug the
tool from its electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer to
the Assembly Diagram near the end of this
manual.
Functions
1. This drill is suitable for drilling operations.
2. The Trigger can be locked in the ON
position for extended operation.
3. The Keyless Chuck allows the operator to
install and remove drill bits without the use
of a separate key or other tool.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at
the beginning of this manual
including all text under subheadings
therein before set up or use of this
product.
Tool Set Up
TO PREVENT SERIOUS
INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to
its “OFF” position and unplug the
tool from its electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
To insert a drill bit, hold the rear ring of the
Chuck (2) with one hand while turning the front
ring with the other. Open the jaws enough to
allow the bit to slide in. Turn the front ring the
opposite direction to tighten the jaws on the bit.
Be sure the bit is centered in the jaws. Tighten
firmly by hand.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent injury
and distraction.
2. Route the power cord along a safe route
to reach the work area without creating
a tripping hazard or exposing the power
cord to possible damage. The power cord
must reach the work area with enough
extra length to allow free movement while
working.
3. Secure loose work pieces using a vise or
clamps (not included) to prevent movement
while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.