Product manual

SKU 94053 For technical questions please call 1-800-444-3353 PAGE 4
ASSEMBLY AND OPERATING INSTRUCTIONS
To Attach Protective Wood Pads To The Pipe Clamp:
1. The Adjusting Screw Housing (1) and Sliding Jaw Housing (2) each are
constructed of steel, and when tightened against the edges of a wooden
workpiece may scratch or dent the workpiece. Therefore, it is recommended that
in order to better protect the surface of the workpiece a wooden pad (not
included) be attached to both the Adjusting Screw Housing and Sliding Jaw
Housing.
2. To construct a wooden pad for the Adjusting Screw Housing (1) and Sliding Jaw
Housing (2), cut two 1/2” thick pieces of a soft wood (i.e., fir or pine) to 1-7/8”
wide by 1-5/8” long. (See Figure A.)
3. Place the wooden pads against the Adjusting Screw Housing (1) and Sliding Jaw
Housing (2), and use the two 7/32” diameter mounting holes in each Housing as
a template to mark the locations where two 7/32” diameter holes will be drilled in
each wooden pad. (See Figure A.)
4. Drill the two 7/32” diameter holes in each of the wooden pads. Make sure to
countersink the holes in order to recess the head of the bolts (not included) that
will be used to secure the wooden pads to the Adjusting Screw Housing (1) and
Sliding Jaw Housing (2). (See Figure A.)
5. Use two 3/4”-1” long by 7/32” diameter Bolts with Lockwashers and Nuts to
secure a wooden pad to the Adjusting Screw Housing (1). Repeat this Step for
the Sliding Jaw Housing (2). (See Figure A.)
1/2”
1-7/8”
1-5/8”
7/32” HOLE
(COUNTERSINK)
WOODEN PAD
(NOT INCLUDED)
BOLT (NOT INCLUDED)
NUT/WASHER
(NOT INCLUDED)
DISC CLUTCH (3)
SLIDING JAW HOUSING (2)
ADJUSTING SCREW HOUSING (1)
3/4” NPT PIPE (NOT INCLUDED)
HAND
CRANK (4)
FIGURE A
LEG
LEG
WOODEN PAD
(NOT INCLUDED)