Product manual

SKU 93458 For technical questions, please call 1-800-444-3353 PAGE 9

due to the possibility of additional parts being damaged when the Jaws were dam-

aged.

e. Insert the Jaws (7) back into the Jaw Cases (6-1, 6-2).

f. When reassembling the Jaw Cases (6-1, 6-2), make sure the wedge on the Jaw

Pusher’s (8) head lines up in between the Jaws, pushing them slightly apart.

SPANNER GAUGE (35)

FRAME HEAD (11)

(THREADS)

JAW CASE

(6-1)

JAW CASE

(6-2)

FIGURE E

Check the distance from the head of the Jaw Cases (6-1, 6-2) to the mounting

threads of the Frame Head (11) using the gauge on the Spanner (35). With the

gauge at a slight incline, the back of the gauge should rest on the beginning of the

Frame Head threads, while the front of the gauge should rest on the front edge of

the Jaw Case (6-1). If it does not, tighten/loosen the Jaw Cases until the distance

is corrected. (See Figure E.)

h. Before reassembly, secure the Lock Nut (12) against the Jaw Case assembly us-

ing the Spanner Gauge (35).

3. Store the Riveter in a clean, dry, safe location out of reach of children.

REV 08i