Product manual

Page 9For technical questions, please call 1-888-866-5797.Item 61932
NOTICE
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
SAFETYOPERATIONMAINTENANCE SETUP
21. Clean the Pinion Shaft (36) of all plastic
protective material and other debris. Clean
debris out of the Motor Pulley (66) hub.
22. Spread a few drops of lubricating oil on the Pinion
Shaft and squarely push the Drum Pulley (26)
onto the Shaft so that the groove in the Pulley
engages the Flat Key (25). The Pulley should
be flush with the step on the Pinion Shaft.
Note: Do not hammer the Drum Pulley onto the
Pinion Shaft. Doing so can damage the unit and
possibly lead to a loose fitting V-Belt (68).
23. Place the Motor (65) onto the Motor Bracket.
24. Use Hex Bolts (28), Flat Washers (55) and Hex
Flange Nuts (5) to secure the Motor to the Motor
Bracket. Hand-tighten all four Hex Nuts since the
motor will be adjusted forward or backward later.
25. Once the Drum Pulley is pushed in all the
way, use a hex key (not included) to tighten
the Screw on the side of the Pulley’s hub.
26. Attach the V-Belt by placing it around the Motor
Pulley (66) and then over the Drum Pulley.
Using a flat-edge screwdriver (not included),
push the Motor inward until the Motor Pulley
is directly under the Drum Pulley. Tighten the
Bolts securing the Motor to the Motor Bracket.
27. Slightly loosen the Hex Bolts (73) holding the Motor
Bracket in place. Push the Motor downward until
the V-Belt tension is tight. When proper V-Belt
tension is achieved, tighten the Hex Bolts (see
Belt Inspection and Tensioning on page 12).
28. Check if Motor and V-Belt turn correctly. Hand
turn the Drum Pulley and verify that Motor
Pulley and Drum Pulley do not rub against any
other part. Adjust Motor location as needed.
29. Mount the Motor Cover (9) to the Motor Hood (31)
using three Hex Bolts (16) and Nuts (32).
CAUTION! Make sure that the power cord from
the Motor to the Switch (13) does not come
in contact with any moving parts.
30. Check all connections to verify that all screws,
nuts, and bolts are securely tightened.