Product manual

Page 8 For technical questions, please call 1-888-866-5797. Item 61932
NOTICE
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
SAFETY OPERATION MAINTENANCESETUP
8. With assistance, set the Lower Drum (48)
with attached Arm (77) and Support
Bracket Seats (35) into Stand assembly
and align the bolt holes. See Figure D.
Lower Drum (48)
Support Bracket
Seat (35)
Arm (77)
Figure D
9. Fasten together using Hex Bolts (71), Flat
Washers (55), and Hex Flange Nuts (5).
Tighten with wrench until secure.
10. Mount Handle Control Plate (41) to Support Bracket
Seat (35) using Hex Bolts (28), Spring Washers
(29) and Flat Washers (30). See Figure E.
Handle Control Plate (41)
Hex Bolt (28),
Washers
(29 & 30)
Arm (77)
Flat Washers (45)
Hex Nut (44)
Hex Bolt (42)
Coil Spring (43)
Control Handle (46)
Figure E
11. Tighten to a point where the Arm (77) can still move.
12. Insert the Coil Spring (43) into
the Control Handle (46).
13. Attach Control Handle to Arm shaft with a Hex
Bolt (42), two Flat Washers (45), and a Hex Nut (44).
14. Use gasket sealer (not included) to stick the Rubber
Gasket (60) to the Upper Drum (59), making sure
the holes in both align. The Gasket must be flat
on the Upper Drum to ensure a proper seal.
15. Place the Upper Drum onto the Lower Drum (48),
making sure the mounting holes align in both.
16. Insert a Screw (57) into each of six
mounting holes. Fasten Drums together
using Flat Washers (58) and Nuts (32).
17. Position each Mixer Blade (62) inside the assembled
Drum with the pointed end facing downward.
The V-shaped bend in the Blades should point in
the direction of the Drum rotation (clockwise).
18. Fasten tops of Mixer Blades to Upper Drum using
Hex Bolts (54), Washers (55), Seal Gaskets
(56), and Hex Flange Nuts (5). Fasten pointed
ends of Mixer Blades to Lower Drum using Hex
Bolts (61), Washers (55), Seal Gaskets (56),
Rubber Gaskets (63) and Hex Flange Nuts (5).
19. Mount the Motor Hood (31) to the Support
Bracket Seat (35) using Hex Bolts (28), Spring
Washers (29) and Flat Washers (30).
20. Use Hex Bolts (73), Flat Washers (55), Spring
Washers (29) and Clamp (72) to attach the
Motor Bracket (6) to the Motor Hood. Tighten
connections until secure. See Figure F.
Hex Bolt
(73)
Flat Washer (55)
Spring Washer (29)
Clamp (72)
Motor Hood (31)
Motor Cover (9)
Figure F