Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 61932
NOTICE
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
SAFETYOPERATIONMAINTENANCE SETUP
Setup - Before Use
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
1. Place the Stand (78) into the Wheel Bracket (4)
so that bolt holes line up. See Figure A.
Note: Set Stand on its side for easier assembly.
Hex Bolts (70),
Flat Washer (55),
Hex Flange Nut (5)
Wheel
Bracket (4)
Leg (79)
Stand (78)
Hex Bolts (69),
Flat Washer (55),
Hex Flange Nut (5)
Figure A
2. Fasten together using Hex Bolts (69, 70), Flat
Washers (55) and Hex Flange Nuts (5). Tighten
with a wrench (not included) until secure.
3. Insert Leg (79) into Stand so that bolt holes line up.
4. Fasten together using Hex Bolts (69, 70),
Flat Washers (55) and Hex Flange Nuts (5).
Tighten with a wrench until secure.
5. Place Stand upright.
6. To attach Wheels (3) to Wheel Bracket, slide a
Flat Washer (2), Wheel and second Flat Washer
onto each end of Bracket axle. See Figure B.
Wheel
Bracket (4)
Wheel (3)
Flat
Washer (2)
Figure B
7. Insert a Cotter Pin (1) through holes in each end
of the Bracket axle and bend the Cotter Pins over
to secure the Wheels in place. See Figure C.
Cotter
Pin (1)
Figure C