Product manual

Page 11For technical questions, please call 1-888-866-5797.Item 61932
NOTICE
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
SAFETYOPERATIONMAINTENANCE SETUP
General Operating Instructions
1. Place the Cement Mixer on a solid, even surface.
WARNING! Do not attempt to move the Cement
Mixer when it is full and/or in operation. Block
the wheels with wheel chocks (not included).
2. Connect the Power Cord to an electric
outlet (or properly rated grounded
three prong extension cord).
3. Add material to the Drum. Typical maximum
quantities include: 2 gallons water with
3 shovels of cement and 15 shovels aggregate
rock (using a size 3 shovel, not included).
4. Adjust the Drum angle by pulling on the Control
Handle. First, disengage the locking pins by
pulling the Control Handle away from the drum
and then pushing on the Handle until the desired
angle is reached. Re-engage the locking pins.
5. Flip the switch to “ON” (I) position.
6. Once materials are mixed, tilt Drum and
dump materials where needed. The materials
are dumped while the Drum is rotating.
CAUTION! Never leave the Cement Mixer running while
unattended. Do not turn Mixer off while full of cement.
7. When finished, flip the Switch to the “OFF” (O)
position and disconnect the Power Cord.
8. Tilt the Drum angle as far down as
possible to drain all fluids from Drum.
9. Clean, then store out of children’s reach.