Product manual

Page 6 For technical questions, please call 1-888-866-5797. Item 66274
Set Up Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
Initial Set Up Instructions
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
1. Slide the Base (2) into the bottom
of the Lamp Assembly (1).
2. Secure with the Knob (3).
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
1. Position the LED work light near the work.
Loosen Knob and adjust Lamp Assembly to
direct the light beam. Tighten the Knob.
2. Plug the Light into a grounded
120VAC electrical outlet.
3. To prevent accidents, disconnect the power
supply after use. Clean, then store the
Light indoors out of children’s reach.
Maintenance And Servicing
Procedures not specically explained in this manual must
be performed only by a qualied technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the On/Off Button is in the OFF position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM LIGHT FAILURE:
Do not use damaged equipment. If damage is noted, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the light. Check for:
• loose hardware,
• misalignment or binding of moving parts
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, allow Light to cool and then wipe
external surfaces of the Light with a clean cloth.
WARNING! If the supply cord of this
light is damaged, it must be replaced only
by a qualied service technician.