Product manual

Page 12 For technical questions, please call 1-800-444-3353. Item 61206
Maintenance
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY, FIRE AND BURNS:
Unplug the Welder and allow all parts of the Welder to cool
thoroughly before service.
TO PREVENT SERIOUS INJURY FROM WELDER FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the
problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the Welder. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the Welder with clean cloth.
3. Periodically inspect Electrode Tips and clean, dress
(resurface), or replace as needed to maintain a
proper contact surface. Refer to Dressing Electrode
Tips on page 9 and Replacing Electrode Tips below.
4. WARNING! If the supply cord of this
Welder is damaged, it must be replaced
only by a qualified service technician.
Replacing Electrode Tips
1. Used Electrode Tips that cannot be
restored to a suitable condition by
dressing will need to be replaced.
2. To replace Electrode Tips, remove used
Tips from the Upper and Lower Tongs.
3. To attach new Electrode Tips to the Upper
and Lower Tongs, coat Tip threads with
heat sink compound (not included) and
screw the Tips onto the Tongs as shown
in Figure F. Do not overtighten.
Upper Tong
Lower Tong
Electrode
Tip
Figure F
SAFETY OPERATION MAINTENANCESETUP