Product manual

Page 15For technical questions, please call 1-888-866-5797.ITEM 62204
SAFETYOPERATIONMAINTENANCE SETUP
Troubleshooting (cont.)
IMPORTANT!
Be CERTAIN to shut off the Plasma Cutter, and disconnect it from power and air before adjusting, cleaning,
or repairing the unit. A technician should discharge all capacitors before performing any internal procedures.
If the steps above do not solve the problem or if the repairs involved are too
complex, contact a qualified technician.
Take note of the
setting required for
this metal thickness.
CUT GOES ONLY PARTIALLY THROUGH THE WORKPIECE
Air pressure too low.
Set Cutter's Air Pressure
Regulator between 60 - 80 PSI.
Turn up the Output Current
Knob and try again at a
slower Torch travel speed.
Material being cut is too thick.
See Maximum Cutting Thickness on page 5.
Use a more
powerful
Plasma Cutter.
WITHIN THICKNESS
RANGE
TOO THICK
a. Verify that the
compressor is delivering
4.5 CFM @ 80 PSI.
b. Set Cutter's Air
Pressure Regulator
between 60 - 80 PSI
AIR PRESSURE
CORRECT
AIR PRESSURE
TOO LOW
PROBLEM
CORRECTED
PROBLEM PERSISTS AT
MAXIMUM CURRENT SETTING
Disassemble Torch, inspect and replace
worn components, then reassemble Torch
tightly according to number 2 on page 10.
Disassemble Torch, inspect and
replace worn components, then
reassemble Torch tightly according
to number 2 on page 10.
TORCH IN GOOD
CONDITION
DAMAGED
COMPONENTS FOUND
Cut at a slower pace, the arc
may not have enough time to
cut through the workpiece.
Maximum cutting speeds:
3/8" Mild Steel @ 10 IPM (Rated)
5/8" Mild Steel @ 5 IPM (Severence)