Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 61717
SAFETY OPERATION INSPECTIONINSTALLATION
Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY: Operation of a vertical hoist involves more than depressing
the UP or DOWN control. The use of vertical hoists is subject to certain hazards that cannot be
met by mechanical means, but only by the exercise of intelligence, care, common sense, and
experience in anticipating the motions that will occur as a result of operating the controls.
Before Operating Hoist
1. Familiarize yourself with all operating controls
of the hoist and with the operation(s) to be
performed. Instructions include, the warnings
on the hoist, and the safety and operating
instructions portion of this manual.
2.
WARNING! TO PREVENT SERIOUS INJURY
FROM HOIST FAILURE:
Do not use damaged equipment.
If adjustments or repairs are necessary,
or any defects are known, have the
problem corrected before further use.
3. Do not operate a hoist with an out-of-order sign.
4. Only a qualified technician should
perform maintenance to the hoist.
5. Do not use the wire rope as a ground for welding.
Do not touch a welding electrode to the wire rope.
6. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
7. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
Note: This winch requires a 20A dedicated circuit.
8. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
9. Inspect the hoist as explained in Frequent Inspection
on page 8 after installation but before use.
Operating Controls
Controller
Emergency
Shut-off
Button
Stop
Bracket
Pulley
Hook
End Hook
Retract
Wire
Rope
(raise
hook)
Extend
Wire
Rope
(lower
hook)
20% Duty Cycle
2 minutes in use
followed by
at least 8 minutes off
This Hoist has a 20% duty cycle. This means that it may
only be run up to 2 minutes at a time and then it must be
allowed to rest for at least 8 minutes before further use.
Emergency Shut-off Button: Press this Button to
shut off the motor and disable the Controller. Twist this
Button to allow it to pop up and enable the Controller.